Table of Contents
Advertisement
Quick Links
LED Work Light Kit
Workman
Model No. 133-0554
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
1. Work light—rear
1. Work-light fuse—15 A
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
MD or HD Series Utility Vehicle
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
107-8008
2. Work lights—front
107-8011
Register at www.Toro.com.
WARNING
CALIFORNIA
Form No. 3404-236 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3404-236* A
Printed in the USA
Advertisement
Table of Contents
Related Manuals for Toro 133-0554
Summary of Contents for Toro 133-0554
- Page 1 Form No. 3404-236 Rev A LED Work Light Kit Workman ® MD or HD Series Utility Vehicle Model No. 133-0554 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Wire harness Route the wire harness. Cable tie LED work light Light channel Work-light bracket Spring washer Hex-head bolt (5/16 x 3/4 inch) Install the LED work lights.
- Page 3 For MD Utility Vehicles Route the wire harness as shown in Figure 1 and secure the wire harness to the machine with cable ties as necessary. Figure 1...
- Page 4 For HD Utility Vehicles Route the wire harness as shown in Figure 2 and secure the wire harness to the machine with cable ties as necessary. Figure 2...
- Page 5 Installing the LED Work Lights Parts needed for this procedure: LED work light Light channel Work-light bracket Spring washer Hex-head bolt (5/16 x 3/4 inch) Figure 4 Locknut (5/16 inch) 1. Flange nut (1/4 inch) 3. Flat washer (1/4 inch) Light-channel-mount bracket 2.
- Page 6 Figure 7 1. Plastic plug 2. Insert the rocker switch into the opening and apply the work-light decal to the left of the rocker switch (Figure Figure 6 1. Opening in the LED work 2. Wire-harness connector light Installing the Rocker Switch Figure 8 1.
- Page 7 2. Connect the wire-harness-terminal ring to the ground-block terminal (Figure 12 Figure 13). Connecting the Wire Harness to the Ground-Block Terminal and Installing the Fuse Parts needed for this procedure: Fuse (15 A) Fuse decal Figure 12 Procedure MD Model Shown 1.
- Page 8 Connecting the Battery No Parts Required Procedure Connect the negative battery cable; refer to your Operator’s Manual. Testing the LED Work Lights No Parts Required Procedure Push the rocker switch up to turn the front LED work lights to the O position.
Need help?
Do you have a question about the 133-0554 and is the answer not in the manual?
Questions and answers