Advertisement
Figure 49
2.
Connect the ring terminal on the harness to
the grounding block and insert the fuse-block
connector into an available fuse-block
connection
(Figure
Note:
If there is not an available fuse-block
connection, you must add a fuse block to the
fuse-block grouping. Contact your Authorized
Service Dealer for more information.
Figure 50
1. Fuse block
50).
2. Ground block
14
Installing the Dash Support
Parts needed for this procedure:
1
Back plate
1
Adjuster plate
g026273
1
Tap bolt (1/2 x 4 inches)
1
Flange nut (1/2 inch)
1
Stop plate
4
Carriage bolt (1/4 x 1-3/4 inches)
4
Flange nut (1/4 inch)
Procedure
1.
Measure 20.7 cm (8-1/8 inches) to the left from
the bottom edge of the hood bracket and mark
the location
1. 20.7 cm (8-1/8 inches)
g027950
16
(Figure
51).
Figure 51
g246001
Advertisement
