Advertisement
10
Installing the Cab Mount
Brackets
Parts needed for this procedure:
1
Left mount assembly
1
Right mount assembly
2
Adjuster bolt (3/8 x 2 inches)
2
Hex nut (3/8 inch)
4
Hex-flange head bolt (3/8 x 1 inch)
4
Flange nut (3/8 inch)
2
Front cab mount bracket
2
Hex-head bolt (7/16 inch)
2
Thrust washer
2
Locknut (1/2 inch)
2
Rubber isolator
2
Spacer
2
Washer
2
Locknut
2
Flange-head bolt (1/2 x 2-1/4 inches)
Procedure
1.
Install the rear brackets on the machine
41) using the previously removed hardware.
Figure 41
2.
Torque the bolts to 94 to 108 N∙m (70 to 80 ft-lb).
3.
Install the left mount assembly and right mount
assembly to the front cab mount brackets using
2 hex-flange head bolts (3/8 x 1 inch) and 2
flange nuts (3/8 inch) on each side
Use the center holes in the mount assembly
when installing.
4.
Install the adjuster bolt (3/8 x 2 inches) and
hex nut (3/8 inch) into the left mount assembly
and right mount assembly on each side of the
machine
1. Flange nuts (3/8 inch)
2. Front cab mount bracket
3. Center holes
4. Left mount assembly
5.
Install the front cab mount brackets using a
(Figure
hex-head bolt (7/16 inch), thrust washer, and
locknut (1/2 inch) on each side
1. Hex-head bolt (7/16 inch)
g026243
2. Thrust washer
6.
Install the 2 rubber isolators using a flange-head
bolt (1/2 x 2-1/4 inches), spacer, washer, and
locknut on each side
13
(Figure
42).
Figure 42
5. Hex-flange head bolts (3/8
x 1 inch)
6. Adjuster bolt (3/8 x 2
inches)
7. Hex nut (3/8 inch)
(Figure
Figure 43
3. Locknut (1/2 inch)
4. Front cab mount bracket
(Figure
44).
(Figure
42).
g245967
43).
g245966
Advertisement
