Led Brightness Setting - Yamato RE202-A/212-A Instruction Manual

Change the LED brightness of the control panel.
The brightness can be set in 8 levels from 0 to 7.
Default setting is "3"
1. Enter user setting
Fwd Rev
Press 2 sec
2. Change LED brightness
Fwd Rev
①
Fwd Rev
③
3. Exit user setting
Fwd Rev
① Turn power ON (|).
② Press the Encoder dial for two seconds while current
AutoR Sync
② ①
① Turn the Encoder dial and select "dSP".
② Press the Encoder dial.
③ Turn the Encoder dial to set desired value.
AutoR Sync
④ Press the Encoder dial to finalize.
①
②
AutoR Sync
④
③
After completing the setting, press the Encoder dial for
two seconds. Display reverts to previous screen and
shows current rpm.
AutoR Sync
Press 2 sec
4. OPERATION PROCEDURES
rpm is on the screen.
Unit enters user setting.
RPM display: "dSP" flashes
RPM display: Current setting flashes
0 (dim) ⇔ 7 (bright)
29

LED Brightness Setting