1. Turn ON (|) pocer
Fwd
Rev
2. Set rotation speed
Fwd
Rev
②
3. Start operation
Fwd
Rev
Press 1 sec to start
① Press the Power key.
AutoR
Sync
①
① Press the Encoder dial.
② Set desired speed by turning the Encoder dial .
AutoR
Sync
③ Press the Encoder dial to finalize.
②
①
③
<To stop>
AutoR
Sync
Speed setting can also be changed during operation.
4. OPERATION PROCEDURES
RPM display: shows software version at start up, then
shows current rpm.
Indicator lamp: One of the Fwd/Rev/AutoR lamps
illuminates according to operation mode at the time of
last power OFF (○).
RPM display: Shows speed setting, flashing.
Speed setting range: 5-315 rpm
Turning the Encoder dial slowly increases or
decreases the value by 1, turning it quickly changes
the value by 10.
RPM display: Shows current rpm.
indicates flashing.
Press and hold
Run/Stop lamp: ON
Press
again.
Run/Stop lamp: OFF
24
Operation Procedure
for one second.