Rotation Modes - Yamato RE202-A/212-A Instruction Manual

Set rotation direction
F.ro: Forward rotation mode
r.ro: Reverse rotation mode
Ato: Timed auto inversion mode
Default setting is "F.ro"
1. Enter user setting
Fwd Rev
Press 2 sec
2. Change rotation mode
Fwd Rev
①
Fwd Rev
③
3. Exit user setting
Fwd Rev
① Press the Power key.
② Press the Encoder dial for two seconds while current
AutoR Sync
②
①
① Turn the Encoder dial and select "rot".
② Press the Encoder dial.
AutoR Sync
③ Turn the Encoder dial to select rotation mode
②
①
④ Press the Encoder dial to finalize.
When operating RE unit in reverse position (bath comes
AutoR Sync
③
After completing the setting, press the Encoder dial for
two seconds. Display reverts to previous screen and
shows current rpm.
AutoR Sync
Press 2 sec
4. OPERATION PROCEDURES
rpm is on the screen.
Unit enters user setting.
RPM display: "rot" flashes
RPM display: Current setting flashes
F.ro: Forward rotation mode
r.ro: Reverse rotation mode
Ato: Timed auto inversion mode
A corresponding lamp among Fwd/Rev/AutoR lamps
illuminates
on left), reverse rotation mode can prevent evaporation
flask from scattering bath fluid toward the front by its
rotation.
26

Rotation Modes