Xantrex XPLORE 120A 12V Owner's Manual page 41

5. Install the provided cable glands prior to routing the cables.
Figure 11 Installing cable glands
A
B
C
D
NOTICE
REVERSE POLARITY DAMAGE
Before proceeding to the next step, carefully check the wiring
polarity. Do not reverse the connections. See note below.
Failure to follow these instructions can result in equipment
damage.
975-1038-01-01
A Cable gland NPT ½
B Cable gland NPT ¾
NOTE: Make sure the positive terminals of the XPLORE Charger
will be connected to the correct terminal of the DC circuit breaker or
a DC fused disconnect and from there to the positive terminal of the
battery. Make sure the negative terminal of the XPLORE Charger
will be connected to the battery negative terminal (or DC negative
bus). Connect the negative cable to the negative DC terminal on the
charger.
27