Common Problems And Their Solutions; Movement; Temperature - IEMAI HIGH-TEMPERATURE Series Operating Instructions Manual

7. Common Problems and Their Solutions

A few common problems are listed, for more questions please contact the technician directly.

7.1 Movement

Problem 1: When extruding, the extrusion gear shake. Increase the print head temperature or determine if
Problem 2: One or two of the X, Y, Z and E axes
cannot be moved, and an alarm sound appears when
you click to move
Problem 3: Opposite direction of motion
Problem 4: When the machine is running, the power
is off with a "bump" sound, and the machine does not
respond when it is turned on again

7.2 Temperature

Problem 1: Click heating, the temperature does not
change, a few seconds later prompted the heating
power is insufficient, check the heating head
temperature rise
Note: Be careful when measuring temperature
Problem 2: Temperature display "1023"
Problem
Problem
the head is clogged or needs to be reloaded with
material.
Check if the limit switch is pressed
Open the firmware and change the control code 1 or
-1
Refer to 4.1.2 Use Automatic leveling to print 8th
Reinstall the print head
Print head is not properly installed
- 38 -
Print More Materials, All For Application
Solution
Solution