Common Problems And Their Solutions; Movement; Temperature - IEMAI MAGIC-HT-PRO Operating Instructions Manual

7. Common Problems and Their Solutions

A few common problems are listed, for more questions please contact the technician directly.

7.1 Movement

Problem 1: When extruding, the extrusion gear shake. Increase the print head temperature or determine if
Problem 2: One or two of the X, Y, Z and E axes
cannot be moved, and an alarm sound appears when
you click to move
Problem 3: Opposite direction of motion

7.2 Temperature

Problem one: click on the heating, the temperature
does not change, a few seconds later prompted the
heating power is insufficient, check the heating head
temperature rise
Attention: temperature measurement careful of high
temperature hot hands
Problem 2: Temperature display "1023"
Problem
Problem
the head is clogged or needs to be reloaded with
material.
Check if the limit switch is pressed
Open the firmware and change the control code 1 or
-1
Whether the print head is installed, or whether the
wire is connected
Print head is not properly installed
35
Print More Materials, All For Application
Solution
Solution