Switching On The Monitor And Video Source - Eizo CuratOR EX5841 Instructions For Use Manual

Operation

6.2 Switching on the monitor and video source

Note
Operation LED
The color of the Operation LED indicates the operating state of the monitor.
See also Troubleshooting
6.2 Switching on the monitor and video source
Note
To obtain the best possible results, the video source should support communication via the
Display Data Channel (DDC) for DVI or the Auxiliary (AUX) Channel for DisplayPort.
The monitor and video source can be switched on in any order.
Switching on the monitor before the video source
ü The video source and power supply are connected correctly.
1. Switch on the monitor.
ð The operation LED lights up yellow.
2. Switch on the video source.
ð If the connected signal can be displayed on the monitor, the operation LED will light
green.
Switching on the video source before the monitor
ü The video source and power supply are connected correctly.
1. Switch on the video source.
2. Switch on the monitor.
ð If the connected signal can be displayed on the monitor, the operation LED will light
green.
CAUTION
Operation LED does not light green?
If the operation LED does not light green after the equipment has been switched on and a
video signal has been applied:
• check the system for basic connection and operating errors before contacting service
personnel.
26
[} 29].
CuratOR EX5841
Instructions for Use, 04/2020