Digital Signal Inputs Of The Monitor; Power Connector - Eizo CuratOR EX5841 Instructions For Use Manual

5.2.3 Digital signal inputs of the monitor

The monitor can process digital input signals at the 12G SDI (IN), HDMI, DP, and DVI con-
nectors of the upper connection panel.
NOTICE
Video source settings
The monitor sends the correct settings to the video source via the DDC interface. If you
change the settings, the images will not be displayed correctly.

5.2.4 Power connector

The device power connector is located within the connection panel under a cover on the
rear of the device. The power supply is connected using an appliance plug.
DANGER
Connecting to line power
• The device is designed for line power with a grounded neutral conductor.
• To avoid risk of electric shock, this device must only be connected to line power with a
protective conductor.
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective conductor.
CAUTION
Risk of damage to the device
• Only use the power cord supplied with the device , or a connection cable with a protec-
tive conductor and an appliance plug in accordance with DIN 49547, IEC 60320 (max.
length 3 m, cable e.g. H05VV-F 3x1.0 mm
ulations of the respective country.
• Device fuses may only be replaced by authorized repair centers. The failure of a device
fuse may result in a defect in the device. Do not use any other fuse.
NOTICE
Line voltage and frequency
Before connecting the device, make sure the line voltage and frequency correspond to the
specifications on the name plate.
CuratOR EX5841
Instructions for Use, 04/2020
2
). The cable must comply with the safety reg-
Connecting
5.2 Device connectors
23