Usage Guidelines; If You Need Assistance; Warranty - InFocus LP210 User Manual

Usage Guidelines

Do not look directly into the projection lens when the projector
•
is turned on. The bright light may harm your eyes.
The top and bottom of the projector can be very hot to the
•
touch after use. Use extreme care or let it cool before lifting it.
Do not block the grills at the front or top of the projector.
•
Restricting the air flow can cause it to overheat and turn off.
Handle the projector as you would any product with glass
•
components. Be especially careful not to drop it.
This projector is not intended for use in mainframe computer
•
rooms as defined in the Standard for the Protection of Elec-
tronic Computer/Data Processing Equipment, ANSI/NFPA 75.
Avoid leaving the projector in direct sunlight or extreme cold
•
for extended periods of time. If this happens, allow it to reach
room temperature before use.
Transport the projector in a vendor-approved hard or soft case.
•
Part numbers for these cases are listed on page 44. Call your In
Focus dealer to order.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check
the guidelines in "Troubleshooting" on page 36.
If this manual doesn't answer your question, call your In Focus
dealer. You can also call In Focus Customer Service directly at
. Call between 5 a.m. and 5 p.m. PST, Monday
1-800-799-9911
through Friday. In Europe, call In Focus in The Netherlands at
. In Singapore, call
(31) 23-5440310
e-mail at
techsupport@infocus.com
Our World Wide Web address is http://www.infocus.com

Warranty

These products are backed by a limited one-year warranty. The
details of the warranty are printed at the back of this manual.
Longer term warranties can be purchased from your In Focus
dealer. Refer to page 44 for part numbers.
. Or, send us an
(65) 740-6435
.
NOTE: If the projector overheats
and turns off, you must wait about
45 seconds before you attempt to
turn it back on.
.
3