Setting Up The Projector - InFocus LP210 User Manual

SETTING UP THE PROJECTOR

1 Place the projector on a flat surface.
The projector must be within 10 feet of your power source
•
and within 6 feet of your computer.
If you want to project from behind a translucent screen, set
•
up the projector behind your screen. See "Rear Projection"
on page 27 to reverse the image.
If you are installing the projector on the ceiling, refer to the
•
LitePro 200 Series Ceiling Mount Installation Guide for more
information. To turn the image upside down, see "Ceiling"
on page 27. The Ceiling Mount Kit is sold separately; see
page 44.
2 Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen
•
determines the size of the projected image. Figure 2 shows
three projected image sizes using the varifocal lens or the
zoom lens at minimum focusing distance. For more infor-
mation about image size, see "Projected Image Size" on
page 50.
3 Make sure the projector and your computer are turned off.
Projected image size (varifocal lens, zoom lens at minimum focusing distance)
25 ft.
10 ft.
4 ft.
F 2
IGURE
5