InFocus LP210 User Manual page 4

S a f e t y
iv
S u m m a r
Power Cord
Use only the power cord that was shipped with the projector.
Although other power cords might be similar in appearance, they
have not been safety-tested with the projector. Do not use a
power cord if it has become damaged or frayed. Contact your In
Focus dealer or call In Focus if you need to replace your power
cord.
Grounding
The projector is grounded through the grounding conductor on
the power cord. To avoid electric shock, plug the power cord into
a properly wired receptacle. Do not defeat the purpose of the
grounding-type plug.
Fuse
For continued protection against the risk of fire, use only the
specified fuse. It must be a time delay, high breaking capacity
5x20mm fuse with the following amperages: for 6.3amp use
T6.3AH, for 8amp use T8AH. Refer to page 42 for more informa-
tion about fuse specifications and to page 33 for instructions on
replacing the fuse.
Lamp
To avoid overheating and unacceptable image quality, replace the
projection lamp with a lamp of the specified type. Refer to
page 41 for lamp specifications and to page 31 for instructions on
replacing the lamp.
Lamp Compartment
To avoid burns, do not open the lamp module door until the pro-
jector is turned off and the lamp has cooled. Follow the instruc-
tions in this manual for lamp replacement carefully.
Hot Surfaces
Allow the projector to cool at least 45 minutes before replacing a
lamp. When you open the lamp housing, be very careful not to
touch the hot surfaces inside.
y