Powering Up The Projector And Adjusting The Image - InFocus LP210 User Manual

Powering up the Projector and Adjusting the Image

1 Remove the lens cap.
2 Plug the power cord into the projector (Figure 8), then plug it
into your electrical outlet. A surge-protected power strip is
recommended if power surges are common in your area.
3 Turn on the projector.
4 If you connected a video player, turn it on.
Press the
•
video
from your video player. Press
computer's image.
Use the
•
volume
If you don't want to hear the sound from your video player,
•
press the
mute
5 If you connected your monitor, turn it on.
6 Turn on your computer.
The computer image should display on the projection
•
screen.
If necessary, use the
•
adjust the brightness. You can make further adjustments to
the image from the projector's on-screen menus. To open
the menus, press the
select the Display menu or the Image menu. For more infor-
mation about the menus, see page 19.
If you don't want to hear the sound from your computer or
•
video player, press the
Connecting the power cord to the projector
button on the keypad to display the image
computer
buttons to adjust the volume.
button.
buttons on the keypad to
brightness
button on the keypad. Then
menu
button.
mute
F 8
IGURE
to return to your
NOTE: Always use the power cord
that shipped with the
projector.
NOTE: With some computers,
the order in which you power up
the equipment is very important.
Most computers should be turned
on last, after all other peripherals
have been turned on. Refer to your
computer's documentation to
determine the correct order.
11