Usage Guidelines; Warranty - InFocus LP 725 User Manual

Usage Guidelines

Do not look directly into the projection lens when the projector
•
is turned on. The bright light may harm your eyes.
Do not block the grills on the projector. Restricting the air flow
•
can cause it to overheat and turn off.
Handle the projector as you would any product with glass
•
components. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold
•
for extended periods of time. If this happens, allow it to reach
room temperature before use.
This projector is not intended for use in a mainframe computer
•
room as defined in the Standard for the Protection of Electronic
Computer/Data Processing Equipment, ANSI/NFPA 75.
Transport the projector in a vendor-approved hard or soft case.
•
Part numbers for these cases are listed on page 52. Call your In
Focus dealer to order.
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in "Troubleshooting" on page 44.
If this manual doesn't answer your question, call your In Focus
dealer. You can also call In Focus Customer Service directly at
. Customer Service is free between 5 a.m. and
1-800-799-9911
5 p.m. PST, Monday through Friday. Service is available in North
America after hours and on weekends for a fee.
In Europe, call In Focus in The Netherlands at
. In Singapore, call
(31) 23-5540310
e-mail at
techsupport@infocus.com
Our World Wide Web address is

Warranty

This product is backed by a limited one-year warranty. The
details of the warranty are printed at the back of this manual.
Longer term warranties can be purchased from your In Focus
dealer. Refer to page 52 for part numbers.
. Or, send us an
(65) 740-6435
http://www.infocus.com.
NOTE: If the projector overheats
and turns off, you must wait about
30 seconds before you attempt to
turn it back on.
5