Replacing The Fuse - InFocus LP210 User Manual

Replacing the Fuse

A power line surge or spike can blow the power supply fuse,
causing the projector to stop working. If this happens, you'll need
to replace the fuse.
The projector ships with a 6.3 amp fuse. The correct replacement
fuse depends on the power line voltage in the country where you
are operating the projector.
If your line voltage is 115V to 240V, use a T6.3AH, 250V,
•
5x20mm fuse.
If your line voltage is 100V to 115V (as in Japan), use a T8AH,
•
250V, 5x20mm fuse. You can order the fuse from your In Focus
dealer; the part number is listed on page 44.
After you make sure that the condition that made the fuse blow
no longer exists, follow these steps to replace the fuse:
1 Turn off the projector by pressing the "O" side of the power
switch.
2 Unplug the power cord.
3 Remove the fuse holder, located just above the power cord
connector. Pull out the fuse holder with a small, flat-blade
screwdriver, key or coin (Figure 25).
F 25
IGURE
Removing the fuse holder
CAUTION: Use only the speci-
fied power supply fuse. Using a dif-
ferent fuse may damage the
projector.
CAUTION: The 6.3A IEC 127
type fuse is required in Europe. In
countries with low main voltage,
you may need the 8.0A fuse to
avoid repeated (nuisance) blowing
of the 6.3A fuse. Both fuses pro-
vide protection from risk of fire. Do
not use the projector if repeated
blowing still occurs after switching
to the 8.0A fuse. Call In Focus
Technical Support for assistance.
33