Normal Operation; Functions - LEAB Clayton Power G3 Combi 1012-50 User Manual

User Manual

9 Normal Operation

Switching On
The device is mounted and installed.
To switch on the device, perform the following steps:
1. Press the on/off button for 2 s.

Red and blue LEDs illuminate.

Red LED goes out.

Blue LED illuminates and indicates the start process.

Blue LED lights up continuously, AC voltage is activated.
The device is switched on.
Switching Off
To switch off the device, perform the following steps:
1. Press the on/off button for 0.5 s.

Blue LED goes out.

Device switches off.
The device is switched off.

10 Functions

Standby Mode
If the AC voltage is not required continuously, a standby mode can be
activated. In standby mode, the internal consumption is less than 2 W. In
standby mode, the device generates a short pulse every 2 seconds.

If the actual consumption is more than 10 W, the device
switches on.

If the consumer is switched off, the device switches to standby
mode after 1 minute.

The standby mode cannot be activated or deactivated via an
external remote switch.

The standby mode is not suitable for lithium batteries.
Page 12 of 22
Normal Operation