Instructions For Use - Otto Bock 1S101 SACH+ Instructions For Use Manual

► To prevent mechanical damage, use caution when working with
the product.
► If you suspect the product is damaged, check it for proper func­
tion and readiness for use.
► Do not use the product if its functionality is restricted. Take suit­
able measures (e.g. cleaning, repair, replacement, inspection by
the manufacturer or a specialist workshop).
Signs of changes in or loss of functionality during use
Decreased forefoot resistance or changes in roll-over behaviour are
noticeable indications of loss of functionality.
4 Scope of delivery
Quantity
1
1
Spare parts/accessories (not included in the scope of deliv­
Fig. Item Designation
2 1 Foot adapter with screw con­
nection
2 2 Connection plate
3 – Ankle block (exoskeletal
design)
4 – Screw connection for ankle
block (exoskeletal design)
– – Ottobock special adhesive
with hardener
Designation

Instructions for use

Prosthetic foot
ery)
Reference num­
ber
2R8*, 2R31*,
2R54*
2R14
2K34=*
2Z22=M10
636W28 or
636W18 and
636W19
5 Preparing the product for use
CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
INFORMATION
► Not all of the materials may be available in your country. In this
case, please contact the local branch of the manufacturer to
obtain information on alternative materials.
5.1 Installing the foot adapter
► Install the foot adapter on the prosthetic foot according to its
instructions for use.
5.2 Installing the ankle block (exoskeletal design)
Required materials: Screw connection (see page 11), 710D20
>
torque wrench, sandpaper (grain size 40), 636W28 Ottobock
special adhesive and hardener, suitable solvent (e.g. 634A28)
1) Insert the threaded socket of the screw connection in the proximal
side of the hole in the ankle block.
2) Insert the screw on the foot sole side in the prosthetic foot and
screw the ankle block to the prosthetic foot (torque: 30 Nm).
3) Conduct the fitting of the ankle block.
4) Loosen the screw connection between the prosthetic foot and the
ankle block.
5) Sand the ankle block according to the contour of the prosthetic
foot.
6) Roughen the connection surface of the prosthetic foot in an a – p
direction using the sandpaper.
7) Remove the dust from the sanded surfaces.
8) Mix the adhesive for the connection between the ankle block and
the prosthetic foot.
11