I Set Mode Programming - Icom IC-M402A Instruction Manual

I Set mode programming

Set mode is used to change the condition of the transceiver's
functions and the microphone's own functions:
Transceiver's functions—
scan mode (Normal or Priority,) scan resume timer, Weather
alert, Dualwatch/Tri-watch, DSC watch, transceiver's beep
tone, LCD contrast (transceiver) and automatic acknowl-
edgement.
Microphone's own functions—
beep tone function (microphone) and LCD contrast (micro-
phone.)
In this section, instructions are for the microphone's own func-
tions only. Refer to pgs. 30 to 32 for the setting of the other
functions. (Some functions cannot be selected from the
HM-127.)
COMMANDMIC
D D Entering Set mode
q Turn power OFF.
w While pushing [16•
], turn power ON.
9
• After a beep emission, a set mode item (in the channel comment
indicator and the condition in the channel number readout) is dis-
played.
e Push [16•
] to select the desired item, if necessary.
9
r Push [Y Y ] or [Z Z ] to select the desired condition of the item.
t Turn power OFF, then ON to exit Set mode.
• Beep tone " "
➥ Push [Y Y ] to turn ON, [Z Z ] to turn OFF the beep output.
Push
• LCD contrast "
➥ Push [Y Y ]/[Z Z ] to adjust to a suitable LCD contrast.
•
" " scrolls at the channel comment indicator.
Push
Scrolls
11
®
HM-127
"
Scrolls
11
47