Icom IC-91A Instruction Manual page 99

D D Digital monitor
Sets the desired monitoring mode during digital mode opera-
tion from "Auto," "Digital" and "Analog."
• AUTO : The transceiver sets monitoring mode to FM
and DV according to the received signal.
fault)
• DIGITAL : Monitors in DV mode.
• ANALOG : Monitors in FM mode.
r
D D Digital repeater setting
When accessing a digital repeater with a call sign different
than is programmed, the repeater call sign can be stored into
"RPT1" and/or "RPT2" automatically by reading the repeater's
transmission. The stored repeater's call sign can be re-called
when selecting the repeater call sign.
r
(de-
r
(default: ON)
r
MENU SCREEN OPERATION
D D RX call sign auto write
When an individual station call is received, the calling station
call sign can be automatically set in "UR."
r
D D Repeater call sign auto write
When accessing a repeater with a call sign different than is
programmed, the repeater call sign can be set into "RPT1"
and/or "RPT2" automatically by reading the repeater's trans-
mission.
r
The transceiver sets the received repeater call sign for op-
eration. Therefore, when a different call sign is set for op-
eration, the previously set repeater call sign will be lost.
11
(default: OFF)
r
(default: OFF)
r
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
93