Checking The Charging Parameter Settings - LEAB RBC 1280 User Manual

LEAB Automotive GmbH

8 Checking the Charging Parameter Settings

To check the charging parameter settings, it is necessary to switch back to
configuration mode.
Check the Charging Characteristic Setting
To check the charging characteristic setting, proceed as follows:
ü The desired charging parameters are set and saved.
ü The charger is disconnected from the 230 V mains.
1. Connect the mains plug to a 230 V mains supply.
2. As soon as the 'Ready for operation' LED lights up blue (after approx. 5 s),
press the Stop button for 10 s until all LEDs are flashing.
ð The device is in configuration mode.
3. Press the Stop button until you are in the desired setting for the charging
characteristic.
ð The LED next to the F1 button lights up orange. The charging characteristic is
set and saved.
Check the battery capacity setting
To check the battery capacity settings, proceed as follows:
4. Keeping pressing the Stop button until you are in the desired battery capa-
city setting.
ð The LED next to the F1 button lights up orange. The battery capacity is set
and saved.
Check the charging mode setting
The charging mode setting can be checked using the following features:
– If one of the charging modes 'Charging mode (25), External input On (26),
CAN mode Master (27), ON:Parallel operation activated (28) or Charging
mode (30)' is set, the LED next to the F1 button is not lit.
– If one of the charging modes 'Power Supply (25), External Input Off (26) or
CAN mode Master ext. (27)' is set, the LED next to the F1 button lights up or-
ange.
LEAB Automotive GmbH
8 Checking the Charging Parameter Settings
Thorshammer 6 24866 Busdorf 15