Table of Contents
Advertisement
Use
6.7.7 Anti-tipper
35
36
6.7.8 Drive-away lock
6.7.8.1 VR2 control unit
INFORMATION
This function is currently not enabled.
For questions related to enabling it, please consult the qualified personnel that adapted the product or the manu
facturer's service (see inside back cover or back page for addresses).
The power wheelchair control unit features an electronic drive-away lock, which is disabled by default.
If the function has been ordered and enabled, the drive-away lock can be activated or deactivated as follows using
the control panel:
Activating the drive-away lock
1) Press and hold the [On/off] switch while the control unit is turned on.
2) Release the [On/off] button after a beep sounds (approx. 1 second).
3) Push the joystick all the way forward until a beep sounds.
4) Push the joystick all the way back until a beep sounds.
→ A long beep confirms that the drive-away lock was activated.
→ The control unit turns itself off.
→ A sequential indicator on the [Selected speed level] LED display indicates that the drive-away lock is active:
Display
Sequential indicator on the "Speed levels"
LED display
Deactivating the drive-away lock
When the unit is turned on, the [Charge level] LED display is off and the [Selected speed level] LED indicator is in
sequential indicator mode.
1) Push the joystick all the way forward until a beep sounds.
48
The anti-tipper makes driving safer (see fig. 35). With
rear-wheel drive, it prevents the wheelchair from tipping
too far backward.
The anti-tipper is mounted so that the ground clearance
is at least 50 mm.
The swing-away, spring-loaded anti-tipper rollers stabil
ise the front-wheel drive power wheelchair when brak
ing while driving downhill.
They swing back when driving against a curb,
for example.
The anti-tipper is mounted so that the ground clearance
is at least 50 mm.
Information
Drive-away lock
Juvo
Advertisement
Table of Contents
