Table of Contents
Advertisement
2-1. INTRODUCTION
This section explains how to initially inspect
the HP 16530/31A Oscilloscope Module, and
how to prepare it for use, storage, and ship-
ment. Also included are procedures tor module
installation.
2-2. INITIAL INSPECTION
Inspect the shipping container tor damage. If
the shipping contaioer or cushioning material
is damaged, it should be kept until the con-
tents of the shipment have been checked tor
completeness and the module has been
checked mechanically and electrically. The
contents of the shipment should be as listed in
the "ACCESSORIES SUPPLIED" paragraph in
Section I.
Procedures for checking electrical perfor-
mance are given in Section
111.
If the contents
are incomplete, if there is mechanical damage
or a defect, or if the instrument does not pass
the performance tests, notify the nearest
Hewlett-Packard office.
If the shipping container is damaged, or the
cushioning material shows signs of stress,
notify the carrier as well as the
Hewlett-Packard office. Keep the shipping
material for carrier's inspection. The
Hewlett-Packard office will arrange for repair
or replacement at Hewlett-Packard's option
without waiting for claim settlement.
2-3. PREPARATION FOR USE
I
WARNING
I
Read the Safety Considerations in the
front of this manual and in Section I
before installing or operating this
module.
H P 1 6 530/31 A - Installation
SECTION II
INSTALLATION
2-4. POWER REQUIREMENTS
All power supplies needed to operate the HP
16530/31A Oscilloscope Module are supplied
to the cards through the backplane connector
of the Logic Analysis Mainframe.
2-5. SAFETY REQUIREMENTS
Specific warnings, cautions, and instructions
are placed wherever applicable throughout the
manual. These must be observed during all
phases of operation, service, and repair of the
module. Failure to comply with them violates
safety standards of design, manufacture, and
intended use of this module.
Hewlett-Packard assumes no liability for the
failure of the customer to comply with these
safety requirements.
2-6. INSTALLATION
Do not install, remove or replace the
module in the instrument unless the in-
strument power is removed.
The HP 16530/31 A Oscilloscope Module con-
sists of two or more cards. The HP 16530A
Timebase Card may have as many as four HP
16531A Acquisition Cards connected to it. For
every additional acquisition card connected, an
extra slot will be used in the card cage.
Procedures for installing the oscilloscope
module and adding acquisition cards are
shown in the step-by-step procedure in para-
graphs 2-7 and 2-8.
2-1
Advertisement
Table of Contents
