Table of Contents
Advertisement
5-1. INTRODUCTION
This section contains parts and ordering in-
formation for the H P 16530/31 A oscilloscope
Module. Table 5-1 lists the reference designa-
tions and abbreviations used t11roughout this
manual. Table 5-2 lists all replaceable parts by
reference designator.
5-2.
ABBREVIATIONS
Table
5--1
lists abbreviations used throughout
the manual. In some cases two forms of the
abbreviations are used, one in all capital let-
ters, the other partially or not capitalized. We
did tt1is because the abbreviations in the parts
list are always all capitals. However, in other
parts of the manual other abbreviation forms
are used with both lower and uppercase
letters.
5-3. REPLACEABLE PARTS LIST
Table 5-2 lists replaceable parts and is or-
ganized as follows:
a. Electrical assemblies in alphanumeri-
cal order by reference designation.
b. Chassis-mounted parts in al-
phanumerical order by reference
designation.
c. Electrical assemblies and their com-
ponents in alphanumerical order by
reference designation.
The information given for each part consists of
the following:
a. Complete reference designation.
b. Hewlett-Packard part number.
c. Total quantity (Qty) of instrument.
HP 16530/31A- Replaceable Parts
SECTION V
REPLACEABLE PARTS
d. Description of part.
e. Check digit.
The total quantity for each part is only given
once at the first appearance of the part num-
ber in t11e list.
5-4. ORDERING INFORMATION
To order a part listed in the replaceable parts
table, quote the Hewlett-Packard part number,
check digit, indicate the quantity required, and
address the order to the nearest
Hewlett-Packard office.
To order a part that is not listed in the replace-
able parts table, include the instrument model
number, instrument serial number, the descrip-
tion and function of the part, and number of
parts required. Address the order to the
nearest Hewlett-Packard office.
5-5. EXCHANGE ASSEMBLIES
Exchange assemblies are available when a
repairable assembly is returned to
Hewlett-Packard. These assemblies have been
set up on the Blue-stripe Exchange program.
This allows the customer to exchange the faul-
ty assembly with one that has been repaired,
calibrated, and performance verified by the
factory. The cost is significantly less than that
of a new assembly.
Exchange assemblies are listed in a separate
section in the replaceable parts table. They
have a part number in the form XXXXX-695XX
(where the new parts would be XXXXX-665XX).
Before ordering a blue-stripe assembly, check
with your local parts or repair organization for
procedures.
5-1
- - - - - - -
- - - - - - -
Advertisement
Table of Contents
