General Information; Introduction; Modules Covered By Manual; Safety Requirements - HP 16530A Service Manual

1-1. INTRODUCTION
This service manual contains information tor
testing, adjusting, and servicing the HP
16531A 400 Msamplejs Digitizing Oscilloscope
Acquisition Card and HP 16530A 400
Msamplejs Digitizing Oscilloscope Timebase
Card. This manual is divided into six sections
as follows:
- General Information
II
- Installation
Ill - Performance Tests
IV - Adjustments
v
- Replaceable Parts
VI
-Service
Information for operating, programming, and
interfacing the H P 16530/31 A Oscilloscope
Cards is contained in the HP 16530/31A
Operating and Programming Manual supplied
with each module.
The General Information Section includes
safety requirements, a product description,
and a list of accessories supplied and of ac-
cessories available. Also included are tables
listing specifications and operating characteris-
tics, and a list of recommended test
equipment.
On the title page of this manual is a microfiche
part number. This number can be used to or-
der 4 X 6 inch microfilm transparencies of the
manual. Each microfiche contains up to 96
photo-duplicates of the manual pages. The
microfiche package also includes the latest
Manual Changes Supplement as well as per-
tinent Service Notes.
HP 16530/31A- General Information
SECTION I
GENERAL INFORMATION
To complete the service documentation for the
system, place this service manual in the 3-ring
binder with your Logic Analysis System
Service Manual.
1-2. MODULES COVERED BY
MANUAL
The information covered in this manual is for
the HP 16530/31A Oscilloscope Module. If
either of the two cards in the module has been
changed, it will have a new board number and
the manual will be accompanied by a Manual
Changes Supplement. ·
This supplement contains the changes and
explains how to adapt the manual to the newer
board. In addition, the supplement may con-
tain information for correcting errors in the
manual. To keep this manual as current and
accurate as possible, Hewlett-Packard recom-
mends that you periodically request the latest
Manual Changes Supplement.
1-3.
SAFETY REQUIREMENTS
Specific warnings, cautions, and safety instruc-
tions are placed wherever applicable
throughout the manual. These must be obser-
ved during all phases of operation, service,
and repair of the module. Failure to comply
with them violates safety standards of design,
manufacture, and intended use of this module.
Hewlett-Packard assumes no liability for the
failure of a customer to comply with these
safety requirements.
1-1