Table of Contents
Advertisement
HP 16530/31A- Installation
g.
Install one cable per acquisition card in the correct timobase card connector, making
sure that you install the correct end. See figure 2-9.
h.
Lay cable(s) flat and pointing out to rear of card. See figure 2-10.
TIMEBASE END
IIAOitXOI
Figure 2-9. Cable End
Figure 2-10. Cable Position
i.
Slide timebase card approximately half way into lowest slpt being used for the scope
module.
j.
Slide acquisition card in half way, feeding cable(s) up through square hole in acquisition
card.
k.
Plug in other end of cable to connector on acquisition card.
I.
Slide next acquisition card in half way, feeding cable(s) up through square hole in ac-
quisition card.
m.
Plug in other end of next cable to connector on acquisition card.
n.
If you have additional acquisition cards, repeat steps I through n until all cards are in half
way and all cables are connected.
2-6
Advertisement
Table of Contents
