Table of Contents
Advertisement
HP 16530/31A- Service
i.
Slide timebase card approximately half way into lowest slot being used for the oscillo-
scope module.
j.
Slide acquisition card in half way, 1eedin9 cable up through square hole in acquisition
card.
k.
Plug in other end of cable to connector on acquisition card. See figure 6-16.
I.
If you have additional acquisition cards, repeat steps
j
and I< until all cards are in half
way and all cables are connected.
Figure 6-16. Installation Summary
6-27
- - - - - - - - - - - - - - - -
- - - -
Advertisement
Table of Contents
