Table of Contents
Advertisement
Solving operating problems
PROBLEM
Cycle time
longer than
usual/Inaccurate
time reading/
Adjustment of
time remaining
during cycle.
Detergent or
fabric softener
remaining in
dispenser at the
end of the cycle.
Washing very wet
at the end of the
cycle.
Vibrating.
36
TROUBLESHOOTING
POSSIBLE CAUSES
Wash time is approximate.
Low water pressure or
flow rate.
Out of balance or
oversudsing.
Washing a large load.
Selecting various options.
Dispenser drawer not
properly closed or was
opened part way through
the cycle.
Dirty or blocked dispenser.
Liquid sitting at the 'Max'
level at the end of the
cycle indicates a blockage.
Dispenser over loaded
with detergent.
Composition of the
detergent makes it
difficult to dispense.
Cycle selected not
appropriate.
Incorrect spin speed for
load selected.
An out of balance load
has occurred.
Transit bolts left in place.
Washer may not be level.
Load is out of balance.
WHAT TO DO
Wash time may be influenced by a
number of factors (refer to page 16).
Ensure that inlet hose filters are not
blocked.
Recovery from out of balance or
oversudsing will extend cycle time
(refer to pages 31 – 32).
Be aware that it will take longer for
the machine to fill.
Be aware that some options will
extend cycle time.
Ensure the dispenser drawer is fully
closed at the start of the cycle and
remains closed throughout the cycle.
Clean the dispenser drawer (refer to
page 28).
Clean the fabric softener dispenser
compartment (refer to page 28).
Clean out remaining detergent and refer
to pages 20 – 21 for dosing information.
Add detergent to the 'MAIN WASH
Powder' dispenser compartment
instead (refer to page 20).
Particularly short or delicate cycles
have shorter spins which can result in
wetter washing at the end of the cycle.
Select a faster spin speed.
The washer compensates for the
out of balance by using a lower spin
speed, to reduce noise and potential
damage to itself.
Ensure transit bolts are removed prior to
use of the machine (refer to pages 5 – 6).
Ensure washer is installed on an
appropriate surface and levelled
correctly (refer to page 8).
Wash an average sized load rather than
a smaller load or a single item. Washing
one item at a time is not recommended
as it is difficult for the washer to
balance a single item during spin.
Advertisement
Table of Contents
