Table of Contents
Advertisement
When a continuous series of beeps is sounded, all the lights turn off on the control
panel and a number appears on the display, a fault has occurred. The washer will
automatically enter this mode if a fault occurs. The fault code will be displayed as
followed by a number on the digital display. To stop the sound, touch any button and
perform the following steps:
Turn your machine off at the power point.
1
Wait one minute and turn it back on.
2
Check that your machine is correctly levelled (refer to page 8).
3
Remove your wash load.
4
Perform a 'Rinse' cycle.
5
If the fault re-occurs repeat steps
6
If the machine still will not work you will be required to call a Fisher & Paykel trained
7
and supported service technician to arrange service (refer to the 'Customer Care'
section). Record the fault code number displayed and the serial number of your washer
(located on the rear of the machine, and/or above the drum opening when the door is
open) before calling. The fault code will indicate to the Repairer what the problem could
potentially be.
If a fault code is being displayed, you can still turn your washer off by pressing 'POWER'.
FAULT CODES
and
.
1
2
33
Advertisement
Table of Contents
