Table of Contents
Advertisement
Cleaning the drum and the door
Use a soft damp cloth to wipe the door, cleaning any water marks or residue off it.
●
●
Wipe the rubber seal around the door. Remove any items or lint accumulating in the
●
●
bottom of the seal catchment and wipe out any water accumulated here. If this is not
cleaned out, unpleasant odours will develop.
If the drum has any residual dirt or lint stuck to it, remove this and wipe the drum clean.
●
●
Do not leave any metal objects in the drum as these may rust and cause staining.
Cleaning the pump filter
The pump has a filter to trap foreign objects that enter the washer along with clothing.
The pump filter can be accessed from the front of the washer. This should be cleaned
out approximately once a month.
To clean the filter:
Turn the power off and unplug the machine.
1
Use a coin to open the filter cover. Place the edge of the coin
2
into the slot and tilt upwards whilst levering the cover open.
Unhook the pump outlet hose and pull it out (about
3
150mm). Remove the plug and allow any water
(approximately 250ml) to drain into a shallow dish.
After the draining process is complete, replace the plug
4
into the hose and refit the hose back into the housing.
Remove the filter by turning anti-clockwise (refer to A).
5
Clean and rinse under a tap. Check the pump filter cavity
for any further obstruction.
Replace the filter by turning clockwise until the turning
6
handle stops in the vertical position, and cannot be turned
further (refer to A).
Close the filter cover.
7
CARING FOR YOUR WASHER
Turn filter clockwise until turning handle
stops in vertical position and tabs meet
Drain residual water
Removing/replacing filter
Tabs
A
29
Advertisement
Table of Contents
