Table of Contents
Advertisement
Electrical connection
This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A
1
electrical supply.
Release the power cord (transit bolts must be removed).
2
Remove and discard the plastic pin cover and plug into a wall socket.
3
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
4
Check the power cord for damage and make sure it is not squashed or twisted when
●
●
installing the washer.
Always remove the power cord from a socket by the plug, not by the cord.
●
●
IMPORTANT!
If you are using an extension cord or a portable electrical outlet device (eg multi-
●
●
socket outlet box), ensure that it is positioned so that it does not come into contact
with water or moisture. FAILURE TO DO SO MAY RESULT IN DEATH OR ELECTRICAL
SHOCK.
Do not touch or operate the machine with wet hands or with bare-feet.
●
●
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
●
●
service technician, in order to avoid a hazard. The appliance must not be operated
until it is repaired, as there is risk of electric shock.
Do not operate this machine if it has been damaged during transport. Contact your
●
●
Fisher & Paykel dealer or Fisher & Paykel trained and supported service technician.
SPARE PARTS
Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported
service technician.
Hose Inlet Long (2m)
Hose Inlet Large Bore
Drain Hose Extension
(Not suitable for attaching to a spigot).
INSTALLATION INSTRUCTIONS
Part No. 422680P
Part No. 426123P
Part No. 425627P
11
Advertisement
Table of Contents
