Connecting To 100Base-Fx Ports - Cisco Catalyst 3550 Installation Manual

Connecting to 100BASE-FX Ports

Figure 2-34 Connecting to an Ethernet Port
M O D E

Connecting to 100BASE-FX Ports

Catalyst 3550 Multilayer Switch Hardware Installation Guide
2-36
S Y S T E M
R P S
S TA T U S
U T IL
D U P L X
S P E E D
1
The 100BASE-FX ports only operate at 100 Mbps and full-duplex mode.
You can connect a 100BASE-FX port to an SC or ST port on a compatible device
by using one of the MT-RJ fiber-optic patch cables listed in
Cisco part numbers in
Table 2-1 MT-RJ Patch Cables for 100BASE-FX Connections
Type
1-meter, MT-RJ-to-SC multimode cable CAB-MTRJ-SC-MM-1M
3-meter, MT-RJ-to-SC multimode cable CAB-MTRJ-SC-MM-3M
5-meter, MT-RJ-to-SC multimode cable CAB-MTRJ-SC-MM-5M
1-meter, MT-RJ-to-ST multimode cable CAB-MTRJ-ST-MM-1M
3-meter, MT-RJ-to-ST multimode cable CAB-MTRJ-ST-MM-3M
5-meter, MT-RJ-to-ST multimode cable CAB-MTRJ-ST-MM-5M
Chapter 2
2
3
Table 2-1 to order the patch cables that you need.
Cisco Part Number
Installing and Starting the Switch
4
5
Table 2-1. Use the
78-11358-03