Pm Timer Reload Events - JETWAY 865GF User Manual

Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake-Up by PCI card /Power On by Ring
During Disabled, the system will ignore any incoming call from the PCI card/modem. During
Enabled, the system will boot up if there's an incoming call from the PCI card /modem.
Wake-Up on RTC Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes
to the operating system, before this function will work

PM Timer Reload Events

Please refer to section 3-8-1
3-8-1 PM Timer Reload Events
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
PCI PIRQ [A-D] #
↑ ↓ → ←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
PM Timer Reload Events
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
F6:Optimized Defaults
30
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults