Table of Contents
Advertisement
T
10.
ROUBLE
If the red
LED is alight:
•
Unplug the rectifier and re-engage.
•
Check AC power to the rectifier.
•
Check for rectifier alarms in the monitor Urgent Alarm list.
•
If symptoms persist, contact a service agent.
If the yellow
LED is alight:
•
Check the monitor Non-Urgent Alarm list.
10.1.
Servicing
DANGER - Do not operate the rectifiers, converters, or other power modules if
the covers are damaged or removed in any way.
WARNING - The rectifiers, converters or other power modules contain voltages
that may be lethal even after the input supply has been removed.
WARNING - The rectifiers, converters or other power modules contain
components at high temperature that may burn if touched
To isolate a rectifier or converter from the power supply, unplug it from the shelf.
The power modules contain no user serviceable components. Do not disassemble the
modules.
If a power module has an operational fault or is damaged in any way, an authorized service
center should service it immediately.
E
11.
SSENTIAL
The following steps are system settings that must be checked at the time of commissioning
for each system installed. You can print this section and fill it out for each site
commissioned.
Note: these steps are battery chemistry dependent. Follow the appropriate section.
11.1.
Systems with Lead Acid Batteries
Failure to correctly follow the items below may cause incorrect system functionality and, in
some cases, ruin your battery (without the ability to claim battery replacement under
warranty).
N
: Any values shown below are indicative only. If the values in your system differ from those
OTE
shown here, write in the values relevant to your system.
Refer to the EM4x energy manager manual for more details.
Newmar • 1580 Sunflower Ave, Suite 100, Costa Mesa, CA 92626
Phone: 714-751-0488 • E-mail: techservice@Newmarpower.com
-
SHOOTING AND
S
S
-
P
YSTEM
ET
UP
S
ERVICING
ARAMETERS
18
Advertisement
Table of Contents
