Table of Contents
Advertisement
1.
Connect the communicating device to the micro-USB port on the front of the energy
manager. See
Figure
17.
A driver installation prompt appears.
2.
Double-click the appropriate USB driver (32bit or 64 bit).
3.
Follow the installation wizard instructions to install the driver.
Micro-USB
4.
Open an internet browser such as Edge, Chrome, Firefox or similar.
5.
Enter the USB default IP address into the internet browser: 172.31.250.1
6.
The energy manager log in page appears.
6. Enter the username and password. See
Note: USB connection to the energy manager is possible without AC, battery or other
external power supply. The EM4x operates drawing power through the USB port. However,
USB supply does not power the IO Board. In this scenario there is a set of alarms that display
depending on the system configuration relating to the nonoperation of the IO board.
For example:
For information on the use of the energy manager Web UI please refer to the Energy
Manager Installation and Operation Manual.
7.4.
Energy manager & IO PCB Alarm Output Configuration
For full EM4x functionality and operation information, refer to the EM4x Installation and
Operation Manual.
7.5.
EM4x LED Alarm Mappings
Refer to the Alarm Configuration>Alarm Configuration page of the Web UI to see the priority
setting of each alarm.
Refer to the Relay/Output page Configure Relay section of the Web UI to understand the
how the Alarm Configuration is mapped to the EM4x LEDs.
Newmar • 1580 Sunflower Ave, Suite 100, Costa Mesa, CA 92626
Phone: 714-751-0488 • E-mail: techservice@Newmarpower.com
7.1 Access
Levels.
13
Advertisement
Table of Contents
