Arm With Omits; Disarming The Panel; Reset After Alarm Condition - Pyronix STERLING 10 User Manual

2.4 Arm with Omits

It is possible to arm the panel with one or more zones omitted (that is, not activated). The sensors for
these zones will not activate the alarm system under any circumstances for that arm procedure.
Enter your 4-digit code
Press the
Func
Enter
Followed by the
Then enter the numbers of the zone to be omitted, (Zones 1 to 8). If, for example, you want to omit
Zone 1 (default text F DOOR), the following will be displayed:
Then press the
The Entry/Exit timer will start to countdown, once armed the chosen zone(s) will be omitted from that
arm mode only. Arming the panel in future will not have these omits enabled unless you omit the
zones again using the above function.

2.5 Disarming the Panel

The panel may be disarmed by entering the building via the Entry/Exit route and entering on the
keypad either the Master Code or any User Code.

2.6 Reset After Alarm Condition

After an alarm condition, enter the user code (Default 1234):
RINS415-9
(LCD) or (ICON) key
key
SPACE
P.A.
Fire
(LCD) or (ICON) key.
Func
Enter
P.A.
Fire
SYSTEM DISARMED
F DOOR
STERLING
A B C
A B C D E F G H I
D
J K L P Q R
M N O
S T U V W X
YZ SPACE
SYSTEM ARMED
ALARM LOUNGE
STERLING
A B C
A B C D E F G H I
D
J K L
M N O P Q R
S T U V W X
YZ SPACE
Sterling 10 User Manual
ARM
Func
Enter
ARM
Func
Enter
Page: 5