Walk Test Mode - Pyronix STERLING 10 User Manual

Press the
Func
Enter
Press the
Func
Enter
Press the
Func
Enter
Press the
Func
Enter
ICON Keypad
Press the
Press the
symbol.
Press the
Press the
Press the
Press the

3.3 Walk Test Mode

The Walk test function allows each of the Arm Modes to be checked in order to verify that all the
intruder detectors on the alarm system are functioning correctly. When undergoing a walk test the
Engineer or Master User can choose which of the Arm Modes they wish to test. Any zone used in
that Arm Mode will cause a chime at the keypad or extension speaker if they are triggered.
LCD Keypad
Press the
Func
Enter
Then the key and scroll to 'WALK TEST'.
Press the
Func
Enter
Use the key to choose the desired Arm Mode you wish to Walk Test,
Then press the
Enter the 4-digit Master Code.
After the countdown timer (default 30 seconds) has stopped, the system is armed and ready to be
tested. When the walk test mode is enabled the keypad will display any activated zones. As shown
below:
This enables all the zone configurations to be walk tested individually.
To exit the walk test enter your 4-digit user code.
RINS415-9
key to perform the next test: 'STROBE TEST' will then be displayed.
key to perform the next test: 'BELL TEST' will then be displayed.
key to perform the next test: 'SOUNDERS TEST' will then be displayed.
key once more to exit System Test.
key, followed by the
key to perform the Display Test – all symbols are displayed except for the Fault
key to perform the Strobe Test.
key to perform the Bell Test.
key to perform the Internal Sounders Test.
key to exit the System Test.
key
key to accept.
key.
Func
Enter
P.A.
Fire
key.
SYSTEM ARMED
F DOOR
STERLING
A B C
A B C D E F G H I
D
J K L M N O P Q R
S T U V W X
YZ SPACE
Sterling 10 User Manual
ARM
Func
Enter
Page: 11