Waking Up The Display And Putting It Back In To An Energy Saving Mode - SMART Board 6000S Series User Manual

Chapter 2 Using basic features
Waking up the display and putting it back in to an
energy saving mode
The display's proximity sensor can detect people up to 16' (5 m) away when the display is in an energy
saving mode. Depending on how the display is configured, it either turns on or enters Ready mode when
the sensors detect people.
Note
On SMART Board 6000S (V3) models, the proximity sensor responds when the display is in the
networked standby and the standby power states. On the 6000S and 6000S (C) models, the proximity
sensor responds only when the display is in the networked standby power state.
If the display is in Ready mode, you can turn it on in a number of ways:
l Press the Power button
Tap the Home button below the screen.
l
Note
The Home button is illuminated when the display is in Ready mode.
l Press the Home button
Pick up a pen or the eraser.
l
Connect a video cable from a computer to a video input receptacle on the display.
l
The display also turns on when it receives a video signal.
The SMART Board 6000S (V3) model returns to Ready mode and 6000S and 6000S (C) models return to
an energy saving mode when one of the following occurs:
The sensor detects no motion in the room for the length of time configured in the display's settings.
l
You press the Power button
l
After entering Ready mode, the display enters an energy saving mode when the sensor doesn't detect
anyone in the room for the length of time configured in the display's settings.
For information about turning off the display, see the SMART Board 6000S and 6000S Pro series
interactive displays installation and maintenance guide (smarttech.com/kb/171414).
smarttech.com/kb/171415
on the convenience panel.
on the remote control.
on the convenience panel or the remote control.
19