Table 2-3 Remedial Action On Each Fault Kind - NEC NEAX 2000 IVS2 Maintenance Manual

CHAPTER 2 TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
(2) Fault Diagnosis and Troubleshooting
Table 2-3 shows the fault information and the remedial action on each fault kind.
shows the fault restoration information on each fault restoration kind. Diagnose contents of
the fault and perform the remedial action listed in
If the corresponding fault restoration kind number shown in
specific action is required.
FAULT
KIND FAULT CONTENT
NUMBER
01 System
Initialization
Page 76

Table 2-3 Remedial Action on Each Fault Kind

FAULT INFORMATION
3: XX XX XX XX
1 2
4: XX XX XX XX
3
1
Kind of System Initialization
related information
1:
2:
F:
2
Initial Kind (See below.)
3
The address of the program
which caused system
initialization
Initial Kind 0: Power On Initialize
Initial Kind 1: Initialize by Reset
Initial Kind 2: Serious Failure 1
Initial Kind 3: Serious Failure 2
Initial Kind 5: Serious Failure 3
Initial Kind 6: Serious Failure 4
Initial Kind 7: Serious Failure 5
Initial Kind 8: Serious Failure 6
Initial Kind 9: SW3 was changed to 0
Initial Kind A: Serious Failure 7
Initial Kind B: Initialize by CAT/MAT
Table 2-3.
3
Program address
information
Receive command
information
No system initialization
related information
Button (SW1)
Table 2-4
Table 2-4 also displays, no
REMEDIAL ACTION
No specific action is required.
Replace the MP card.
Replace the MP card.
Replace the MP card.
Replace the MP card.
Replace the MP card.
Replace the MP card.
No specific action is
required.
Replace the MP card.
No specific action is required.
2
NEAX2000 IVS Maintenance Manual
ND-70926 (E), Issue 3.0