Table of Contents
Advertisement
CO03 – Control via USB, capturing on A, B, and ETH
CO03 – By using the USB port for controlling DANEO 400, the ETH port becomes available as a third
Figure 5:
In configurations as shown above, it is not recommended to enable the tap mode of
DANEO 400. Depending on the features and the configuration of the Ethernet switches,
either a loop with potentially circulating packets will be established or a spanning tree
(STP) algorithm will disable a network link.
CO04 – Tapping a trunk link
CO04 – The Ethernet ports A and B are configured as a tap. DANEO 400 is inserted into the link
Figure 6:
between switches and can capture all traffic exchanged over this link.
port for traffic capturing.
Connections and interfaces
17
Advertisement
Table of Contents
