SIIG MultiView CE-H26311-S1 Manual page 12

6.4 Web UI
You can connect the Ethernet directly from PC to Multiview KVM
Processor.
Please follow below steps to configure your PC Ethernet setting.
6.4.1 Directly Connect to PC via Ethernet Cable
12
a. Click Start > Control Panel > Network and Sharing
Center
Click "Change Adapter Settings"
b.
c. Highlight the network adapter you want to use to
connect to the device and click "Change Settings" of this
connection. The "Local Area Connection Properties"
window for the selected network adapter.
d. Highlight the Internet Protocol Version 4 (TCP/IPv4)
e. Click Properties. The Internet Protocol Properties
window is relevant to your IT system.
Select "Use the following IP Address for static IP
f.
address" and fill in the details.
use any IP address in the range 192.168.1.1 to
192.168.1.255 (excluding 192.168.1.202).
g. Subnet mask fills in 255.255.255.0.
Click "OK".
h.
For TCP/IPv4 you can