Table of Contents
Advertisement
g.
Connect the audio output connector to the audio amplifier, as
required.
h.
Connect the keyboard and mouse to the corresponding USB
connectors above the HDMI output connectors.
i.
Connect the 12V/2A adapter to 12V DC connector.
5.2 Rack Mount Installation
Take the following steps to attach the two brackets to the system
chassis and install into rack.
a.
Remove all cables and power supply before mount the Multiview
KVM Processor in the rack
b.
Place the system chassis on a sturdy surface
c.
Attach bracket to the left side of the system chassis by using the
screw driver and four screws
d.
Attach the other bracket to the right side of the system chassis by
using the screw driver and four screws
e.
Use your tape to measure and ensure that the supporting shelf
and the chassis are installed straight and level
f.
Make sure that your path to the rack is unobstructed.
g.
Slide the unit into the rack and position using the attached L
brackets so that the slots in the brackets are positioned over the
appropriate mounting holes in the side rails of the rack
h.
Securely fasten the unit into the rack by using the four screws
provided in the kit. Install two of the screws on each side of the
unit and tighten them with a screw driver.
10
Advertisement
Table of Contents
