Figure 1-2, Electrical Connection Points - Magnum Energy MagnaSine Hybrid Mobile Series Owner's Manual

DC Equipment Ground Terminal – this connection is used to tie the exposed chassis
7
of the inverter to the DC grounding system. This terminal accepts CU/AL conductors from
#14 to #2 AWG (2.1 to 33.6 mm
AC Entry/Exit Connections – two 3/4" knockouts provided with cable-clamp
8
reliefs to accommodate and secure the AC input and output
Intake Air Vents – ventilation openings to pull in air to help keep the inverter cool for
9
peak performance. The intake air vents are located on the front side and at the front on
the right side; also see Figure 2-3 for the location of the air vents.
Positive DC Terminal – provides a 360 degree connection point for the positive (+) cable
10
from the battery bank; consists of a 5/16-18 bolt with a Kep or Flange nut that holds the
battery cable to the DC terminal.
Negative DC Terminal – provides a 360 degree connection point for the negative (-)
11
cable from the battery bank; consists of a 5/16-18 bolt with a Kep or Flange nut that
holds the battery cable to the DC terminal.
12 Mounting Flange – used to secure the inverter to a shelf or wall.
8
AC Entry/
Exit
Connections
7
DC
Equipment
Ground
Terminal
© 2013 Magnum Energy, Inc.
).
2
Intake Air Vents
(and on right side - front)

Figure 1-2, Electrical Connection Points

fi eld wiring.
9
Introduction
strain
10
Positive (+)
DC terminal
(under cover)
11
Negative (-)
DC terminal
(under cover)
12
Mounting
Flange
Page 4