Table of Contents
Advertisement
Press and release the Program Key ( ) to keep the stored Low Temperature Limit for that
•
Channel.
Adjust the stored Lower Temperature Limit using the keypad. (
•
Press and release the Program Key ( ) to proceed to the next channel or the next step once
•
Channel 3 has been set.
Automatic Setback Timer
What is Temperature Setback? To preserve tip life and save energy, the system can automatically adjust the Set
Tip Temperature to a lower value after a selected period of inactivity (factory setting of 30 minutes).
7.
The display will be showing "Set SetBack Time".
Time is shown in minutes and can be adjusted
between 10 to 90 minutes in one minute
increments. Attempting to enter a value less than
10 minutes will set the timer at 0. Leaving this
setting on 0 will disable the Automatic SetBack
which results in the irons running at the Set
Temperature continuously unless an Instant SetBack cubby is also being used.
Press and release the Program Key ( ) to keep the currently stored Temperature Setback time.
•
Adjust the stored Temperature Setback value using keypad. (
•
Press and release the Program Key ( ) to proceed to the next step.
•
SetBack Reset
SB Reset = Sel – Allows users to selectively end SetBack on individual channels by first pressing the
•
Scroll Up or Down Keys (
Program Key ( ) and finally using the Scroll Up Key ( ) or Scroll Down Key ( ) to end SetBack for that
channel.
SB Reset = All – Allows users to end SetBack on all channels at once by first pressing the Scroll Up or
•
Down Keys (
Down Key ( ) to exit SetBack on all channels.
Upon exit of SetBack, the unit will resume normal operations and the handpiece will heat up, returning to the Set
Temperature.
8.
The display will show "SB reset = XXX" with "XXX" representing "Sel" or "All" meaning the unit will end
SetBack on an individual channel Selectively or on All of them.
• Change between Sel or All by using the Scroll Up Key ( ).
• Press and release the Program Key ( ) to keep the currently displayed option and continue to the next
setting.
©2022 PACE Inc., Vass, North Carolina, All Rights Reserved
) to enter Temperature Set Mode, then selecting the desired channel using
) to enter Temperature Set Mode then again pressing the Scroll Up Key ( ) or Scroll
The MBT360 may have more than one handpiece
connected. SetBack Reset provides fine control of how
each handpiece channel can be brought out of SetBack by
selecting them individually or by returning all of them to
normal operation at once.
)
)
Page 11
Advertisement
Table of Contents
