AUTOMATIC SHUTDOWN
10. The system enables the Automatic Shutdown
feature only when the Automatic Setback
feature is enabled. No additional steps are
necessary.
CHANNEL SELECTION
11. The Channel 1 LED is now lit signifying
that Channel 1 is ready for calibration.
Perform steps 12 through 21 to calibrate.
As channels change, repeat these steps
for each channel.
All temperature limits are stored in
system memory in degrees °F
LOWER TEMPERATURE LIMIT SETPOINT
12. Press and release the Tip Temperature Set Key. The
Digital Readout will now display "L-X" (X = 1-9). This is
the stored value of the Lower Temperature Limit in
increments of 100°F. For example, if the "L-5" is
displayed, the lower limitis500°F.
©2012 PACE Incorporated, Southern Pines, NC All Rights Reserved. Printed in the USA
NOTE
www.paceworldwide.com
3