MTS ROW Assembly Instructions
PREVENTIVE MAINTENANCE TIPS
ACTION
DAILY
CLEAN
Upholstery
X
Guide Rods
Linear Rods
Shields
Hand Grips
INSPECT
Belts
X
Hardware
Frame
Hand Grips
LUBRICATE
Linear Bearing
Guide Rods
Range Limiter
Clean:
•
Upholstery with a mild soap and water.
•
Guide and linear rods with a cotton cloth.
•
Hand grips with mild soap and water.
Inspect:
•
Cables for wear or damage and proper tension (should not exceed ¾" deflection). Pay
close attention at bends and attachments points.
•
Hardware should be checked for looseness. Tighten as required.
•
Frames should be inspected for wear or damage.
•
Hand grips should be checked for wear or damage.
Lubricate:
•
Linear bearing with TF1000 grease (part number SK50-P0004-0000).
•
Guide rods with Break-Free (part number SK50-P0005-0000). Apply the Break-Free to a
cotton cloth, then run the cotton cloth up and down the guide rods as needed.
•
Range limiting device should be cleaned and lightly oiled using Break-Free (part number
SK50-P0005-0000).
22
MONTHLY
QUARTERLY
X
X
BI-ANNUALLY
YEARLY
X
AS NEEDED
X
X
X
X
X
X
X