Advertisement
1. Bolt together seat assembly. The seat assembly is shipped in three pieces as shown below.
Fasten the chest pad and seat cushion to the seat assembly by lining up the bolt holes in the
cushions with the bolt holes in the seat frame. Using a ¾" socket wrench, fasten the chest
pad to the seat frame using four 3/8" x 1-1/2" bolts and 3/8" flat washers. Fasten the seat with
two 3/8" x 2-1/2" bolts and 3/8" flat washers.
Install chest pad
3/8" x 1-1/2" bolt
w/flat washer (4)
Plastic washers (4)
Install seat cushion
3/8" x 2-1/2" bolt
w/flat washer (2)
Use 9/16" socket to
tighten nut and 5/32"
hex key to install sleeve
NOTE: AT THIS POINT, YOU MAY WISH TO BOLT THE BASE OF
THE SEAT ASSEMBLY TO THE BOTTOM BRACE OF THE MTS ROW.
USE 2-3/4" BOLTS AS SHOWN IN FIGURE 6 IF YOU WISH TO DO
THIS.
Assembly Figure 1. Build the seat assembly.
MTS ROW Assembly Instructions
Use 3/4" socket to
loosen bolts to
install chest pad
3/8" x 1-1/2"
UPHOLSTERY
BOLT
3/8" x 2-1/2"
UPHOLSTERY
BOLT
7
Advertisement
