Hammer Strength MTS ROW Unpacking And Assembly Instructions page 13

Hide thumbs Also See for MTS ROW:

7. Bolt the left arm to the frame. Slide the left arm up into the top of the MTS ROW with the

arm facing inward as shown at left. Insert two ½" x 2-3/4" bolts on the outside of the arm

through the bushing and tighten. Insert two ½" x 2-3/4" bolts through the inside bushing and

tighten. All bolts should be inserted through the top piece. Nuts and star washers should be

on the bushings as shown in the detail view in the figure.

NOTE: MAKE SURE THE HANDLE IS FACING INWARD AS SHOWN

IN THE FIGURE BELOW.

Assembly Figure 7. Bolt left arm to frame.

MTS ROW Assembly Instructions

1/2" x 2-3/4"

(4)

Arm detail

2-3/4" BOLT