Hammer Strength MTS ROW Unpacking And Assembly Instructions page 15

Hide thumbs Also See for MTS ROW:

Assembly Figure 9. Connect the belts to the weight stack.

10.

Run the belts through the arm pulleys and bolt down the belts. Thread the belts from

the weight stacks through the arm pulleys to the belt plate. With the weight stack pin in the

bottom (150 lb.) plate, pull the belt until it's tight. Use the 3/8" x 1-1/4" bolts and plates

(circled) and tighten down the belt to 20 ft/lbs. Cut off the belts leaving about one inch

beyond the belt plate. Use a heavy scissors or utility knife to cut off the belt.

Assembly Figure 10. Belt routing through arm pulleys. Cut off excess.

NOTE: THE 3/8" STAR WASHERS THAT LOCK DOWN THE BELTS

TO THE ARMS WILL NEED TO BE REPLACED EACH TIME THE

BOLTS ARE LOOSENED FOR BELT MAINTENANCE.

MTS ROW Assembly Instructions